How jetting works
Drain jetting sends a hose with a specialized nozzle down the line, spraying high-pressure water backwards and sideways as it advances. The rear-facing jets pull the hose forward and scour the pipe walls; the flow flushes loosened sediment back out the way it came or through to the discharge. Unlike a rigid rod that pokes a hole through a blockage, jetting cleans the full diameter of the pipe — which matters, because a poked hole re-clogs in months while a scoured pipe starts over clean.
When jetting wins
Sediment, shingle grit, composted leaf sludge, and soft root intrusion are jetting's home territory — the large majority of residential downspout line blockages. The pipe stays in the ground, the lawn stays intact, and the job is done in a visit. It's also the right diagnostic first step: how the line responds to jetting tells you a lot about its condition.
When digging is the honest answer
Jetting can't fix geometry. A crushed pipe, a collapsed section, a separated joint, or a line laid with reverse slope will block again no matter how clean it is. Heavy structural root intrusion — where roots have deformed the pipe, not just grown into it — usually means replacing that section. When we find those conditions, we'll tell you plainly rather than sell you a jetting visit with a short shelf life. Everything we jet is exterior stormwater: downspout lines, yard drains, and catch basins.
